|
|
FAQ on Dinlog
Petrol Saver PS 110
1.Q: What
is Dinlog? What is PS110?
Ans: Dinlog is brand name of this product. PS110 denotes the
grade of Petrol Saver. It also indicates it is ideal for engines with 110cc
i.e. two wheelers with or about 110cc
2.Q: It is
such a small bottle and the quantity mentioned is just 5ml. why?
Ans:
There is no smaller bottle than this. So a 10ml LDPE bottle is being used to
fill 5ml of Dinlog PS110. Actually about 8 ml is
filled in while filling the bottle to take care of any evaporation losses.
3.Q: How
many litres of Petrol really 5ml can be used with?
Ans:
Actually 1 ml is equal to approximately 30 drops. So about
150 drops is available inside the bottle. This
150 drops can be applied to 100 litres of Petrol in a
100~110 cc bike. If it is a 70cc Moped this 150 drops can be used with 150 ltrs of Petrol.
4.Q: The
product smells like Kerosene or Diesel. What is so special about the product?
Ans: Yes
the product is made of diesel only but it is a Catalyst in diesel form so it
can be easily added with Petrol and will not evaporate easily. The specialty is
this Dinlog PS110 gives very good extra mileage for
sure and is very good for Petrol engines.
5.Q: For
the price of Rs.52 for 5 ml what are the value of benefits?
Ans: Fuel
is saver about 15% to 25%. Smoke is reduced by about 60%; Pick up and speed
increases by about 30%. Engine noise is greatly reduced; Engine becomes smooth;
Engine heat is reduced by 20%. The value of fuel savings alone is estimated at
15% on 100 ltrs of Petrol say 15 litres
of Petrol at current price of about Rs.70/ltr of petrol the savings works out
to Rs.1050 against the cost of just Rs.52 plus above mentioned additional
benefits.
6.Q: It
is mentioned as a Dosage Specific Catalyst. What it means?
Ans: It
means the same. Dosages with reference to the CC of the 2 wheeler must be
strictly followed. Otherwise mileage benefit will not come. All other benefits
are achieved even in wrong dosages. But for mileage increase dosages must be
strictly followed. The specific dosages for each type of known bikes are as
given in the webspage.
7.Q: Why
so little dosages? How to put 1½ drops for 1 litre of
Petrol?
Ans: Dosages
are fixed to achieve extra mileage after testing in 100s of Bikes. The User can
put 3 drops for 2 litres of Petrol or 1.33 litres for a TVS 50 and put 1 drop for a dosage of ¾ drops
per litre.
8.Q: What
happens if instead of 1½ drops 2 drops are added for 1 litre
of Petrol?
Ans: The
power of the Bike increases. The RPM falls down. And hence extra
mileages is not achieved. It 2
drop per litre is continue to be applied instead of 1½ drops then mileage
gets reduced. So avoid putting extra dosages than prescribed except for the
first time.
9.Q: If
mileage gets reduced due to extra dosages how to recover the mileage?
Ans: Put half of the prescribed dosage until mileage is recovered and then
continue with normal dosage.
10.Q: What happens if only 1 drop is applied for 1 litre of Petrol instead of 1½ drops?
Ans: RPM
increases and so mileage gain may not be much. So dosages must be as
prescribed.
11.Q: Do you have any approvals or Licences?
Ans:
Approvals are required for setting up big factories of for manufacture of
listed products like Cars or Military Hardware. For Fuel savers no such
licensing is required.
12.Q: Will the increased mileage come for long term use?
Ans: Yes.
But to sustain increased mileage the RPM of the Bike must be maintained. To
maintain good RPM now and then it is recommended to apply half a drop lesser
than the normal dosage. If the User follow this advise
the mileage improvement continue for ever.
13.Q: Is there any chemical in the product? Will that harm my
engine bore and piston?
Ans:
There is no chemical in the product. Actually as the product cools down the
engine by 20% engine wear and tear is reduced and this is good for the engine
life.
14.Q: Can I get this product in my Town?
Ans: One
can get this product anywhere in